Fault code checking on a K9 1000

Colacharlie

New member
Mar 24, 2016
18
1
3
46
East Grinstead, West Sussex
How do I check fault code on GSXR 1000 K9? All the wires at the block (I think I’d check from) are black with green bits and all look very similar??
Is the block I’ve shown in the pic the right one to check from?
 

Attachments

  • 8A722F16-F3D2-440D-B5F8-FC80E9C27696.jpeg
    8A722F16-F3D2-440D-B5F8-FC80E9C27696.jpeg
    1.1 MB · Views: 207

GixxerGod

Super Moderator
Staff member
Jan 18, 2012
400
26
18
Milton Keynes
The dealer mode connector is under the tail cowling on the left side of the bike, near the regulator/rectifier. It will have only two wires going to it. It is is small white connector that does not plug into anything, and has a rubber cap on one end.

I’ll check to see if I have any notes on your specific model
 

GixxerGod

Super Moderator
Staff member
Jan 18, 2012
400
26
18
Milton Keynes
I have stuck a probe from a multi meter into the wiring harness up at the connecting block to the fuel pump but I’m not getting any power (for when the bike usually primes). Any ideas?

I don't I'm afraid, I'll ask a mechanic I use if he has any ideas.